Anatomage - Changing Table Orientation (Vertical and Horizontal)

2022

Changing Table Orientation (Vertical and Horizontal)

The Anatomage table can transition between a horizonal and vertical orientation depending on the specific use case. This article provides a short tutorial on how to switch between the two.

Horizontal to Vertical Mode

Prior to changing the physical position of the panel, switch the software into Vertical Mode via the Options Menu.

Locate the Options icon and open the Options Menu.

Tap Layout at the top of the Options Menu.

Tap "Enable Vertical" to toggle vertical mode.

Prior to making any changes, ensure the wheels located on the left side are locked to prevent the table from moving while in transition.

Press down the tabs onBOTHwheels.

Locate the two locking mechanisms that keep the screens in place. The top keeps it in the horizonal, the bottom right in the vertical.
Unlock the horizontallock by pushing the lever from the locked to unlocked position. This frees the monitor panel and allowsit be lifted.
Prior to lifting the monitor panel ensure the vertical locking lever on the right bottom side is set to unlock.
Slowlyliftthe panel from the left side to transition to the vertical orientation. Be careful as it is heavy, especiallywhen almost in the vertical position.
Oncevertical lock it into place by pushing the vertical lock upwards. This prevents it fromshifting back accidentally.


Vertical to Horizontal

Prior to transitioning back to Horizontal, ensure you toggle "Enable Vertical" off from the Options menu. Refer to the instructions at the top of this article.

Prior to making any changes, ensure the wheels located on the left side are locked to prevent the table from moving while in transition.

Press down the tabs onBOTHwheels.

Locate both panel locking levers.
Release the vertical lockby pushing it down towards unlock.
Slowly pushthe monitor panel to the horizonal position. Be careful as it is very heavy, especially when almost completely horizonal.
When the panel is in the horizonal position lock it in place by pushing the locking lever to the left.
Posted by: Matthew Kilbride - May 7, 2021. This article has been viewed 4453 times.
Online URL: https://kb.mc3.edu/article.php?id=11386

Powered by PHPKB (Knowledge Base Software)